From any camera to an alert on your phone

Ceptory takes footage from the cameras you already have and understands it. It checks the footage against your rules, then tells the right people, with the photo, in seconds.

Your sources

IP cameras & NVRsVia edge box or Desktop
Webcams & USBBrowser or desktop app
Raspberry Pi & devicesOne line to install
Drones, OBS, encodersPush a live stream
Recorded videoUpload or sync clips

Ceptory

Secure intake
  • A key for each camera
  • Live frames and streams
  • Activity clips, uploads
Vision models
  • People · vehicles · plates
  • Faces · PPE · fire, smoke
Your rules
  • Intrusion · loitering
  • PPE · parking · falls
  • → alert with the photo

Clips and uploads

Video index
  • Search in plain words
  • Ask about any footage
Dashboard & DesktopLive view, alerts, search
Phone pushAct in one tap
Slack, Teams, emailPlus webhooks
AI agentsAsk over MCP
Live run · simulated0 frames · 0 alerts · 0 held back
    Latest alert

    Waiting for the first rule to fire…

    Each alert arrives with the photo that triggered it, on the dashboard, on phones and in team chat.

    Live frames and alerts Clips, uploads and search

    Step by step

    Four stages, one flow

    Every source goes through the same stages, so a webcam, an NVR and a drone all alert the same way.

    1. 1

      Connect a source

      Use a camera on this computer, an IP camera or NVR, a Raspberry Pi, or anything that can push a live stream, like OBS, a drone or an encoder. You can also upload recorded video.

    2. 2

      Ceptory understands it

      Vision models look at live frames for people, vehicles, number plates, faces, safety gear, and fire or smoke. Clips and uploads are indexed, so you can search them in plain words.

    3. 3

      Your rules decide

      Each camera watches for the rule you picked, in the area you drew: intrusion, loitering, missing PPE, illegal parking, crowding, or a person down. Nothing alerts unless a rule says so.

    4. 4

      The right people know

      Each alert has the photo that triggered it. It lands on the dashboard, in Ceptory Desktop, on phones, and in Slack, Teams, email or webhooks. Your AI agents can ask about it too.

    Connect

    Use the cameras you already have

    Pick a camera's source when you add it. You can switch a camera to streaming from a device later in its settings.

    Computer cameras

    Webcams, USB and capture devices work in the browser or in Ceptory Desktop. There's nothing to install on the camera.

    IP cameras and NVRs

    Ceptory Desktop or a small edge box on your network reads the camera's stream. Only activity leaves the building.

    Raspberry Pi and devices

    One command installs a small service that starts on boot and sends frames. You open no ports, and it connects outbound only.

    Drones, OBS and encoders

    Push a live stream to Ceptory with the server address and key from the camera's settings.

    By design

    Built to share as little as possible

    A key for each camera

    Devices use a key that can only send footage for one camera. It can't read anything. You can make a new key or revoke it at any time.

    Passwords stay on site

    Camera addresses and passwords stay on your computer or edge box. Ceptory sees only the footage you send.

    Send only what matters

    Edge boxes send only clips with activity. Live cameras send a frame every few seconds, at the rate you set per camera.

    Alerts you can check

    Each alert has the photo that triggered it and the rule that fired, so you can review it, resolve it, or mark it as a false alarm.

    Get started

    Connect your first camera

    Start with a webcam or an example video in a few minutes. Then add your real cameras.